Description
DILUNETT® is a stripper that easily removes all traces of residue from your surface. Formulated with water, it provides your surface with greater resistance and better adhesion for the new coating. Quick and efficient, it breaks down the coating to be removed (paint, varnish, adhesives, etc.) and then rinses effortlessly to leave you with a clean surface ready to be repainted.
Ideal for your DIY projects and home staging.
Properties
Strips paints, varnishes, stains... without scraping.
Also removes pigments deeply.
Makes the coating water-soluble: removes it by simple rinsing.
Does not evaporate, does not dry out in high heat.
Reactivates upon wetting.
Scrape-free
Effective, up to 8 layers of paint in one application:
Also removes pigments deeply.
Makes the coating water-soluble: removes it by simple rinsing.
Does not evaporate, does not dry out in high heat.
Reactivates upon wetting.
Scrape-free
Effective, up to 8 layers of paint in one application:
Destination
Effective on wood**, PVC, metal***...
Effective for stripping up to 8 layers of paint in one application.
Works on glycerophthalic and acrylic coatings.
Does not strip two-component coatings, baked paints, fast-drying paints, or rubber-based paints.
It may be necessary to repeat the operation.
** Except Oak, Chestnut, Red Cedar, and marquetry.
*** Except aluminum
Effective for stripping up to 8 layers of paint in one application.
Works on glycerophthalic and acrylic coatings.
Does not strip two-component coatings, baked paints, fast-drying paints, or rubber-based paints.
It may be necessary to repeat the operation.
** Except Oak, Chestnut, Red Cedar, and marquetry.
*** Except aluminum
Recommendations before application
Always perform a preliminary test.
Wear rubber gloves and use a nylon brush or a paste brush.
The action time varies from a few minutes to several hours depending on the type of coating (glycerophthalic or acrylic) and the number of layers. Check its action with a spatula.
Since stripping is never neutral on absorbent surfaces, neutralization is always recommended.
Wear rubber gloves and use a nylon brush or a paste brush.
The action time varies from a few minutes to several hours depending on the type of coating (glycerophthalic or acrylic) and the number of layers. Check its action with a spatula.
Since stripping is never neutral on absorbent surfaces, neutralization is always recommended.
Application
Apply a thick layer of DILUNETT over the entire surface to be stripped.
Allow the product to work.
If it dries, reactivate by lightly spraying with water.
Rinse with clean water using a brush or a high-pressure cleaner (up to 60 bars).
Note: The use of hot water makes removal easier.
After stripping wood, always apply NET-TROL (on wet wood) IMMEDIATELY after rinsing DILUNETT.
Refer to the instructions on the packaging for further details.
Allow the product to work.
If it dries, reactivate by lightly spraying with water.
Rinse with clean water using a brush or a high-pressure cleaner (up to 60 bars).
Note: The use of hot water makes removal easier.
After stripping wood, always apply NET-TROL (on wet wood) IMMEDIATELY after rinsing DILUNETT.
Refer to the instructions on the packaging for further details.
| Application temperature | +10°C to +30°C |
|---|