LIANFLOOR® : Waterborne joint

• Acrylic filler for joints, cracks, holes, or defects not exceeding 2 mm gap.
• Used in combination with sawdust from sanding (grains #80 to #100).
• Prevents the blades from sticking together when varnishing. This way, the joints maintain their cushioning role.

• Parquets, floors, interior stairs, whether new or old.
• Compatible with clear or tinted PRIMAFLOOR®* basecoats, varnishes, and saturators from the DURIEU range, oils, and other varnishes (compatible with acrylic binders).
• Suitable for all wood species.

• Shake LIANFLOOR® well before mixing it with sawdust.
• Do not apply at an ambient air and wood temperature below 15°C and above 25°C.
• The wood must be clean, dry, non-greasy, and free of any finish before application.
• Compatible with the insecticide and fungicide treatment SANIXYL on raw wood, before the complete varnishing process.
• Protect anything that should not be treated.
• In all cases, comply with the current standards/DTUs.

• Mix LIANFLOOR® with the sawdust from the final sanding in a stainless steel bucket or directly on the floor to create the filling paste.
• Apply the mixture using a stainless steel spatula or putty knife.
• Once dry, if the filling shrinks (resulting in hollow joints), repeat the operation without sanding between the 2 coats.
• Sand the treated area (with grit #80 or #100).
• Thoroughly vacuum the surface after each sanding.
• Proceed with the various steps of the varnishing process.