TEAK PROTECT : Marine teak and cork saturator

Protect your teak and cork woods from the harshest weather conditions with TEAK PROTECT. This saturator deeply nourishes your woods and ensures long-lasting high protection for your decks and garden furniture.

Easy to use, it applies with a brush or roller and dries in 15-20 minutes. Two coats are necessary to ensure optimal protection and preserve the natural appearance of wood and cork.

High-nutrition, long-lasting protection against the harshest weather conditions.
Bridges, furniture, sun loungers... All wood.

Ready-to-use, non-film-forming transparent protection. Water-based. Does not chip.
Excellent deep penetration of the substrate: does not form any surface film.
Reinforced UV protection for long-lasting performance even in the harshest weather conditions.
Preserves the natural appearance of wood and cork. Enhances the grain and natural beauty of the substrate, allowing cork to breathe while protecting it from water and humidity.
Directly applicable to prepared new or old wood, free from any coating.
Easy maintenance without sanding or stripping.

Exterior use.
All woods: Teak, Ipé, Bangkirai, Acacia, Massaranduba, Douglas, Larch, Oak... Iroko/Azobé (contact us for advice).
All vertical and horizontal surfaces: decks, pontoons, gratings, handrails, furniture, steering wheel...

The wood must be clean, dry (3 days of dry weather - maximum wood humidity 18%), sound, and prepared according to the applicable standards - free from dust, mold, grease stains, and any old coatings.
Do not apply in direct sunlight during the hottest hours of the day. Ensure that it will not rain within 24/48 hours after application.
The relative humidity should be around 50% for optimal drying. Be cautious of morning dew.
Protect anything that should not be treated.

Do not dilute. Mix the product well before and during application to avoid any risk of sedimentation.
Apply a generous layer of TEAKPROTECT along the wood grain and over the entire length of the plank, focusing on the ends.
Apply a second layer when the wood no longer appears wet (approximately 15 to 20 minutes after the first layer). Never let it dry between coats. Apply "wet on wet."
Smooth out any excess product (or wipe it off) before it dries to avoid any drip marks or shine upon drying: TEAKPROTECT should penetrate into the wood and not remain on the surface.
If applying with a spray gun, smoothing is always recommended to improve penetration and achieve a uniform appearance.