PRIMAFLOOR® : Wood primer + water-based wood stain

PRIMAFLOOR® is a tinted or clear isolating hard primer. Designed for all wood species, it evens out surfaces and enhances the adhesion of the varnish. Single-component, ready to use. Light-resistant, does not yellow.
Slows down the formation of stains on tannin-rich or naturally oily woods.

Prevents the sticking of blades and joints.
Requires no polishing either by hand or with a single-brush machine.
For parquets, floors, stairs, new or old (free from any finish).
Available in 7 intermixable shades.

• Applies to raw wood before varnishing.
• Enhances the durability of the varnish and ensures optimal results.
• Isolates the substrate (especially in the case of tropical woods) before varnishing.

• Parquet, flooring, interior stairs, whether new or old.
• Applicable to all wood species.

• To avoid deep scratches from sanding, perform a test sanding with a parquet sander equipped with a grit #40 or #50.
• Based on the visual result obtained, gradually continue with a finer grit up to #80 or #100, or start with a coarser grit (< #40) for a dirty and uneven floor.
• Use an edge sander for the edges, a scraper, or a wood chisel for the corners.
• If necessary, fill cracks < 2 mm with LIANFLOOR®* and resume sanding with #80 or #100 grit depending on the last used grit.
• Finish with sanding.

Shake the product well.
Apply a coat of PRIMAFLOOR®, ensuring thorough penetration.
Start with the edges, then cover the entire surface, working in 2m x 2m sections.
Do not open windows during application to prevent too rapid drying.
The milky appearance of the product will quickly disappear to become transparent.
For some tropical woods or those rich in tannins, it is possible to apply two coats of PRIMAFLOOR® with an hour interval without exceeding 8 hours. This base coat will provide significantly better insulation.