SI106-pack-fr

SI 106

Waterborne, penetrating wood finish
si106-diapoA1
picto_rendement Coverage: 4-6 m²/l per 2 applications
picto_temperature Application temperature: +10°C to +35°C
picto_temps Dry time: 4 h

PROPERTIES

SI 106 is a waterborne, penetrating wood finish for industrial application. Based on a mix of alkyd and acrylic resins, SI 106 is non-film forming, so will not crack, peel or flake. Saturating, sealing and stabilising the wood, it minimises cracking, warping and other damage caused by the sun and moisture. Containing premium, UV absorbing transoxide pigments, SI 106 provides a long lasting,rich matt finish on soft and hardwoods, accentuating the natural beauty of the wood.

Functions

  • Excellent penetration even on dense and oily tropical woods - Teak, Ipe...
  • Low viscosity.
  • Environmentally friendly.
  • Quick drying - Handle and stackable in 4 hours.
  • Provides an anti-fungal finish.
  • Easy maintenance - No sanding or stripping.
  • Fast commissioning - 24 hours in unconfined atmosphere.

WHERE TO USE

  • Interior and exterior.
  • Horizontal and vertical surfaces - Decking, cladding, fences...
  • All new and weathered wood.
  • All wood types - Soft and hardwoods, Heat Treated wood, Pressure treated and non-pressure treated wood...
  • All wood species - Pine, Cedar, Ipe, Mahogany, Ironwood...

SURFACE PREPARATION

General directions:

  • Surfaces must be clean, dry and free of dirt, grease, grime, mildew and previous coatings.
  • SI106 can only be applied to bare wood surfaces. ALL other finishes/sealants MUST be completely and thoroughly removed.

New wood surfaces:

  • No special preparation required.

Dirty, weathered and contaminated surfaces:

Previously finished/sealed wood:

Application

Spray, brush coater, flow coating, vacuum coating:

  • Apply 2 even applications of SI106 ‘wet on wet’.
  • Apply a 1st liberal application of SI106 and allow to penetrate into the wood.
  • Apply 2nd application as soon as the wet look of the 1st application has disappeared (normally 10-15 minutes) and allow to penetrate into the wood.
  • Brush out any puddles within 20 minutes of applying the last application to avoid SI106 drying as shiny spots on the surface.
  • Do not allow SI106 to become Touch Dry or Dry between applications.

Dipping:

Note: SI106’s place is in the wood, not on the surface. Do not create a film on the surface, as this will affect the coatings performance.

Recommendations after Application

  • Hot water and detergent.

Color available

Related Products

pack-N4 owatrol-fr

N4

Multi-Surface Cleaner
ro_pack-GB-DE

OWATROL OIL

Colourless, penetrating and isolating rust inhibitor
pack-pid-60

PID 60

Universal anti-corrosive primer